This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
nslu2_install_debian [2011/01/27 23:57] jap |
nslu2_install_debian [2011/01/29 22:23] jap |
||
---|---|---|---|
Line 22: | Line 22: | ||
7. In disk partition phase, select manual partition. Allocate both ext2 and swap partitions. Select ''noatime'' option and set mount point ''/'' | 7. In disk partition phase, select manual partition. Allocate both ext2 and swap partitions. Select ''noatime'' option and set mount point ''/'' | ||
+ | |||
+ | 8. Once installation is ready, configure your setting and do some optimization for flash and low memory use. | ||
+ | |||
+ | Network settings ''/etc/network/interfaces'' | ||
+ | iface eth0 inet static | ||
+ | address 192.168.1.20 | ||
+ | network 192.168.1.0 | ||
+ | netmask 255.255.255.0 | ||
+ | gateway 192.168.1.1 |