This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
nslu2_install_debian [2011/01/27 22:37] jap |
nslu2_install_debian [2011/01/29 22:23] jap |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| # sudo apt-get install upslug2 | # sudo apt-get install upslug2 | ||
| - | 2. Download and extract latest stable installer image (unofficial version with proprietary code) | + | 2. Download and extract latest stable installer image (unofficial version with proprietary code). At the moment of writing this, the 6.0 Beta2 release does not appear to install properly. Device reboots when performing hardware detection. Latest stable 5.0.4 works fine. |
| http://www.slug-firmware.net/d-dls.php | http://www.slug-firmware.net/d-dls.php | ||
| Line 22: | Line 22: | ||
| 7. In disk partition phase, select manual partition. Allocate both ext2 and swap partitions. Select ''noatime'' option and set mount point ''/'' | 7. In disk partition phase, select manual partition. Allocate both ext2 and swap partitions. Select ''noatime'' option and set mount point ''/'' | ||
| + | |||
| + | 8. Once installation is ready, configure your setting and do some optimization for flash and low memory use. | ||
| + | |||
| + | Network settings ''/etc/network/interfaces'' | ||
| + | iface eth0 inet static | ||
| + | address 192.168.1.20 | ||
| + | network 192.168.1.0 | ||
| + | netmask 255.255.255.0 | ||
| + | gateway 192.168.1.1 | ||